TouchPoint^™

TouchPoint is the parlor display and keypad for controlling milking procedures at each stall point. Constructed of super-durable engineered resin, TouchPoint can be mounted in a cabinet or as a stand alone unit on herringbone or parallel stalls and can be integrated into rotary milking cabinets. TouchPoint is the direct parlor link to the SmartDairy software and provides complete command and control of the entire milking process.

The TouchPoint display provides stall position, cow number, milk yield and flow rate in real time and gives warnings on deviations from your cow's normal milking levels. Enter commands, recall data or custom program function keys through the TouchPoint keypad.

Pulsation Control through TouchPoint^™

1. With TouchPoint, pulsation can be controlled and managed at each stall point. No master control is needed.
2. Program pulsation to stop when the milking unit is detached on each individual cow. Save unnecessary run time with power saving mode when your pulsators are not in use.
3. Special pulsation rate/ratio is pre-programmed for the wash cycle. This pulsation rate/ratio during washing saves run time and maintains liner integrity.
4. Pulsation control at the TouchPoint allows more flexibility when designing your milking facility.

QuickStart^™ with SmartDairy^™

1. Lift the milking claw to take the tension off the rope or chain, and vacuum is automatically sent to the milking unit and cylinder is extended. No buttons to push. No extra steps. Saves extra motion for your milking crew, so attention can be focused on your cows.